Basic Functions; Volume Adjustment; Multi-Language Voice Messages; N-Com Easyset - N-Com B601 R Serie Mode D'emploi

EN
Fig. 27
Fig. 28
4

BASIC FUNCTIONS

Note: Before using the N-Com device for the first time, recharge the battery completely for at least 10 hours.
To obtain best performances from the battery, it is recommended to completely recharge the battery the first
few times. Afterwards, you can recharge the battery for shorter periods. Whenever possible, it is best to
recharge the battery completely.
System ON
System OFF
4.1

Volume adjustment

You can easily adjust the volume by tapping the ""or "" key. You will hear a beep when the volume reaches
the maximum or minimum level.
The volume is independent for each sound source. Once it is set for a specific source (phone call, radio, Mp3),
it will be remain in memory even after the system is switched off.
However, if you adjust the volume during stand-by mode, it will affect volume levels of every audio source.
4.2

Multi-language voice messages

The N-Com system features voice messages that provide information on the system and on the active
functions. The language set by default is English. The language of the voice messages may be changed
through the specific firmware installable with the N-Com EASYSET program. Please refer to the online HELP for
instructions on how to change the language settings.
Available languages: Italian, English, French, German, Spanish, Dutch.
The default function is enabled on the device. You can enable / disable the "VOICE
ANNOUNCEMENTS" function by using the N-Com EASYSET program.
4.3

N-Com EASYSET

"N-Com EASYSET" is the application that can be used to manage and configure the B601 system.
The programme can be downloaded from the Internet site www.n-com.it, in the "Download"
section. The functions that can also be managed from the N-Com EASYSET are listed here below
with the specific icon.
14
Press "n" and keep it pressed for about 2 seconds, until the LEDs turn on and
you hear the voice announcement.
Press "n" and keep it pressed for about 6 seconds, until the LEDs turn off and
you hear the voice announcement.
•
Unhook the right and left clips from the shell,
levering upward using a flat head screw (or a
similar tool), as shown in figure 27.
•
Completely remove the B601 system from
helmet using a flat head screwdriver (or
similar tool) and re-install the cheek padding
and the edge gasket.