Pairing The System - Dometic PERFECTVIEW VT150DIG Instructions De Montage Et De Service

VT150DIG
➤ Connect the green cable of the transmitter module (fig. 6 5, page 5) to the positive wire of
the reversing light.
➤ Connect the camera connector (fig. 6 4, page 5) to the camera.
7.3 Connecting electrical power to the receiver module
➤ Connect the monitor connector (fig. 7 4, page 5) to the monitor.
➤ Switch on the monitor.
✓ The message "NO SIGNAL" appears on the monitor.
✓ A yellow triangular symbol appears on the monitor.
8

Pairing the system

I
NOTE
The transmitter module and the receiver module have to be paired with each other so
that the monitor can display the camera images. This is conducted at the factory.
8.1 Pairing the system manually with the pairing button
➤ Press the pairing button on the receiver module (fig. 7 2, page 5).
✓ The blue LED on the receiver module (fig. 7 3, page 5) flashes.
✓ The monitor displays the message "PAIRING START" and a counter that counts down 50 s.
You need to perform the pairing of the transmitter module within 50 s.
➤ Press the pairing button on the transmitter module (fig. 6 2, page 5).
✓ The blue LED on the transmitter module (fig. 6 3, page 5) flashes.
✓ The modules synchronise themselves with each other.
This takes approx. three to five seconds. For successful pairing, the picture appears.
If pairing is unsuccessful, the monitor displays the message "NO SIGNAL". Repeat the pairing
procedure.
EN
Pairing the system
15