Connecting Electrical Power To The Radio Link - Dometic PERFECTVIEW VT150DIG Instructions De Montage Et De Service

VT150DIG
If the camera image transmission is stable (two or three reception bars at the top right of the
monitor), you can complete final installation of the two modules.
If faults occur (only one reception bar or a yellow warning triangle on the top right of the
monitor) turn or move the transmitter or receiver module slightly and conduct further tests.
Attaching the modules (fig. 8, page 6)
To do this, proceed as follows for each module:
➤ Hold the module at the chosen location and mark the four points for drill holes.
➤ Drill holes with a Ø of 4 mm at each of the points you just marked.
➤ Screw the module on with M5 x 20 mm self-tapping screws.
Fixing the antennas (fig. 9, page 6)
I
NOTE
Always align the antennas in the same direction, for example, both vertically.
This improves the transmission performance. Best transmission performance can be
worked out when the round shaped antenna sides of transmitter module and receiver
module are directed to each other.
➤ You can glue the antennae on the corresponding module.
7

Connecting electrical power to the radio link

7.1 General notes on laying cables
I
NOTE
•
As far as possible, use original ducts for laying the cables, or other suitable options
such as panelling edges, ventilation grilles or dummy plugs. If no openings are avail-
able, you must drill holes for the cables. Check beforehand that there is sufficient
space on the other side for the drill head to emerge.
•
Cables and connections that are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
Therefore, please observe the following instructions:
•
Wherever possible, lay cables inside the vehicle, as they are better protected there than
outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
•
To prevent damage to the cables when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heaters
etc.).
EN
Connecting electrical power to the radio link
13