Honeywell TURBO FORCE HF71X Série Manuel D'instructions page 3

For FCC and RSS-210 compliance information, please see page 6 of this manual.
WARNING:
Solid-State Speed Control Device.
FUSED SAFETY PLUG - FOR US MODELS ONLY
This fan features a fused safety plug which is designed to cut off electric current to the fan if an electrical
fault occurs. Please see below for more information on how to properly use your fan and replace the safety
plug fuse, if needed.
USER SERVICING INSTRUCTIONS
• If your fan loses power and you suspect that the fuse on your fan has blown,
grasp plug and remove from the receptacle or other outlet device. DO NOT
unplug by pulling on cord.
• Slide fuse cover, located on the top of the plug, towards the prongs of the plug.
(Fig. 1)
• Carefully remove the blown fuse and snap a new fuse into place. To reduce the
risk of fire, replace fuse only with 2.5 Amp, 125 volt fuse. Fully close the fuse
door by sliding back into place. (Fig. 2) Discard the blown fuse. The plug should
now be ready for normal use.
To Reduce the Risk of Fire, DO NOT replace attached plug. The plug
•
contains a safety device (fuse) that should not be removed. Discard
product if the attachment plug is damaged.
• If you need further information on how or when to replace the fuse in the
safety plug, please contact our Consumer Relations department at
1-800-477-0457. You may also visit our website at:
www.HoneywellPluggedIn.com.
INTRODUCTION
The Turbo Force® Power Oscillating Air Circulator Fans are aerodynamically
designed to give you the versatility of changing the fan's angular direction
simply by adjusting the fan to the desired angular output. (Fig.3) Upon using
the fan, you will feel a strong and powerful air stream that will quickly move air
to provide a cooling effect.
FOR AIR CIRCULATION ALL YEAR
Honeywell Air Circulator Fans increase distribution of cooler air from your air conditioner or warmer air from
your heating system, creating a vortex of air flow for increased comfort. Increased air flow allows the air
conditioning and heating systems to be used at lower settings.
In the summer:
Circulate cool air by using
with window or central air
conditioning.
Circulate cool air upstairs
To Reduce The Risk of Fire or Electric Shock, DO NOT Use This Fan With Any
In the winter:
Circulate warm air. Position your air circulator in an open location for
upward air movement. Run it on a low setting to move the hotter air
from the ceiling and circulate the warmer air throughout the room.
Increase Heating Source Efficiency:
Use with other heat sources, such as wood stoves, baseboard heaters,
and or vents to help circulate the warm air throughout the room.
3
Fig. 1
Fig. 2
Fig. 3