1. General information
The operating instructions must always be preserved during the lifetime of the product. It summarizes the
key safety measures.
It must be read by everyone working with the product so that they know to handle it properly.
The pressure switch XMLW must be used only for the purposes for which it was intended.
EX-TECH SOLUTION shall not be held liable for damages resulting from incorrect or improper use or non-
compliance with this manual.
Only authorized and trained persons are authorized to perform work on the flameproof control station
(installation, commissioning, maintenance, maintenance).
During installation and operation, it is imperious to follow the instructions (technical characteristics and
operating conditions) written on the marking plate of the pressure switches XMLW.
2. Manufacturer
– Formerly Technor Atex
Ex-tech Solution
22, impasse de la Volute – Z.A. les Montagnes
B.P. 20708 – 16430 Champniers – France
Tel: + 33 5 45 93 01 10 – Fax : + 33 5 45 93 01 15
E-mail: sales.solution@ex-tech.no – www.ex-tech.no
3. Storage and transport
Check that the product was not damaged during the transport. If necessary, make a complaint to the
carrier
Never turn on damaged products
The product should be stored for a maximum of two years into a place dry (no condensation),
enclosed, covered, protected from contact with external chemicals and to temperatures of -40°C ...
+70°C and vibration-free
4. Use
The pressure switches XMLW described in this manual are certified II 2 GD and can operate into the
classified zones 1 and 2 for gases or 21 and 22 for dusts.
5. Function
The range of pressure switches Ex Tech Solution allows you to control the fluids in your installation in
hazardous areas.
XML008A12-07 01/12/2016
Operating instructions
Pressure switch - series XMLW
ENG
9/16