Assembling The Stand; Assembly Procedure - Pioneer PDK-TS04 Mode D'emploi

Assembling the Stand

Note
Always assemble it on a flat table etc.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.

Assembly Procedure

1
Select the support columns to attach.
Select the support columns according to the type of
plasma display that you have purchased and to the
speaker settings with reference to the following
stipulation. Note that only one of the two types of
available support columns should be used.
When installing speakers on both sides of the
plasma display
[Support column used: support column S]
Support column used:
support column S
When installing speakers at the bottom of the
plasma display
[Support column used: support column L]
Support column used:
support column L
14
En
2
Attaching the support columns to the stand.
Insert the head of the screw in the support column into
the hole for the support column in the stand and then
slide it downward.
Front side
3
Attach the support column to the stand
with the attachment screws 1 on the left
and right of the stand.
Use the enclosed hexagonal wrench to vertically tighten
it in the top hole from the rear.
4
Fully tighten two screws on left and right
of stand which have been loosely screwed
into stand.
Use the provided hexagonal wrench to fully tighten the
attachment screws which have been loosely screwed in
on the left and right sides of the stand.
5
Reconfirm that the attached screw is
firmly tightened.
Support column
attachment hole
Attachment screw 1
Tighten the two screws
which have already
been screwed into the
stand.