Cleaning The Water Tanks - ALPATEC F 10 FC Notice D'utilisation

Notice F 10 FC:Notice Fontaines
• Periodically the water dispenser tanks must be cleaned to prevent unpleasant tastes in the water and to
remove mineral deposits that can impair flow.
1. Before cleaning, set the power switch to off, and unplug the power cord. For a water dispenser used for
the first time, go to Step 5.
2. Remove the bottle or the filtering tank.
3. Drain water from the water tank of the water dispenser. (See Drain from water dispenser)
4. Replace the silica gel plug and bottom cover.
5. Do not directly inject bleaching powder into the water dispenser, as concentrated bleaching powder
solution may damage plastics. Fill a 2L bottle with water, and add about 2.5ml bleaching agent of 6.0%,
and gently swing it to get it homogeneous. Fit an adaptor onto the bottle and place it on the water dis-
penser (See Loading the dispenser).
6. Press the hot water key, cold water key and cool water key (depending on respective types), so that
water flows out homogeneously from both taps of the water dispenser.
7. Wait for about 10-15 min.
8. Completely drain the water from the bottle, and remove the bottle. Drain water from the water tanks of
the water dispenser (see Drain from water dispenser), and put on the water dispenser plug.
9. Add clean water into the water dispenser bottle and drain water from the taps until no more water flows
out, and drain water from the water tanks of the water dispenser (see Drain from water dispenser).
10. Repeat previous Step (9) for 2 ~ 3 times.
11. Drain water from the water tanks of the water dispenser (see Drain from water dispenser), put on the
plug, fit the bottom cover and screws with a screwdriver.
12. Operate as per "Loading the dispenser", and the water dispenser can be used normally.
The power supply to the water dispenser can be turned ON only
out from both taps of the water dispenser homogeneously.
9/12/09 14:10

CLEANING THE WATER TANKS

CLEANING THE WATER TANKS
CAUTION
when water can flow
14
Page 14