ALPATEC F 10 FC Notice D'utilisation page 13

Notice F 10 FC:Notice Fontaines
Press corresponding button hot water (3) to fill the glass with water.
Hot water use advice:
As the heating process is extremely fast, we advice you to switch off the hot water switch (8) as soon as
you finish to use it. Moreover, this will allow you to make economies on energy.
CARE AND CLEANING OF THE DISPENSER
CARE AND CLEANING OF THE DISPENSER
Drain from water dispenser
The remaining water should be drained from the water tank when the tank is to be cleaned or the water
dispenser will not be used for a long time.
1. Set the switch on the back of water dispenser to off position, and unplug the power cord of the water
dispenser.
2. Remove the bottle from the water dispenser.
3. Drain the water in the water dispenser until no water flows out from the tap.
4. Put the water dispenser on a basin, and lift it. Unscrew the cold and hot water drain buttons and
complete drain the water from the water dispenser.
5. After complete draining, fit on the plug, cover and screw again.
Warning:
• Do not hold the dispenser up side down
to drain the water. It may cause the
water flow about the inside unit and short
circuit may occurs.
• It is strictly forbidden to remove the silica
gel plug when there is hot water in the
water dispenser.
• Before turning on the power supply and connect the power switch on the water dispenser, make
sure there is a bottle with sufficient water on the water dispenser, and water can flow out from
9/12/09 14:10
both taps. (Please refer to "Loading the dispenser").
13
Page 13