Upholstery Cleaning; Transport; Storage; Care And Service - Kärcher Puzzi 10/1 Mode D'emploi

Masquer les pouces Voir aussi pour Puzzi 10/1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
Heavily soiling or stains
1. Apply cleaning solution with the suction
turbine switched off and let it work for 10
to 15 minutes.
2. Clean the area as with normal soiling.
3. If necessary, clean the area again with
clear, warm water to further improve the
cleaning result.

Upholstery cleaning

1. Puzzi 10/1 only: Fit the manual nozzle
instead of the floor nozzle.
2. Use less detergent for sensitive fabrics
and spray the surface at a distance of
approx. 200 mm. Then only vacuum.
Cleaning tips
 Spray heavily soiled areas in advance
and allow the cleaning solution to work
for 5 to 10 minutes.
 Always work from light to shadow (from
window to door).
 Always work from the cleaned to the un-
cleaned area.
 The more sensitive the covering (orien-
tal bridges, Berber, upholstery fabric) the
lower the concentration of detergent.
 Carpets with jute backs can shrink and
bleed in colour if the work is too wet.
 Brush wet pile carpets in the direction of
the pile after cleaning when wet (e.g.
with a fibre brush or scrubber).
 Impregnating with Care Tex RM 762 af-
ter wet cleaning prevents the textile cov-
ering from being quickly soiled again.
 To avoid pressure points or rust stains,
do not walk on or furnish the cleaned ar-
ea until after it has fully dried.
Detergent
Carpet and upholstery
cleaning
Defoaming agent
Carpet impregnator
For further information, please request the
product information sheet and the EU safe-
ty data sheet for the relevant cleaning
agent.
RM 760 powder
RM 760 tabs
RM 764 liquid
RM 761
RM 762
English

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
1. Place the suction pipe on the carrying
handle for transport and place the spray
/ suction hose on the device. Wind up
the mains cable and hang it in the cable
hook.
Illustration C
2. When transporting the device in vehi-
cles, secure it to prevent it from slipping
or overturning in accordance with the re-
spective valid guidelines.

Storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
storage.
The device may only be operated indoors.

Care and service

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Clean the fluff filter
1. Remove the cover.
2. Remove the wastewater container from
the device.
3. Clean the fluff filter regularly with a
brush.
Clean the fresh water filter
1. Unscrew the fresh water filter.
2. Clean the fresh water filter under run-
ning water.
Clean the nozzle
1. Unscrew the union nut.
2. Clean the nozzle mouthpiece.
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Puzzi 10/2 adv

Table des Matières