Publicité
Les langues disponibles
Les langues disponibles
Keep cord from heat, oil, and sharp edges.
12) Don't grasp the exposed cutting blades or
cutting edges when picking up or holding
the appliance. (For grass shears and
similar appliances only.)
13) Don't Force Appliance - It will do the job
better and with less likelihood of a risk of
injury at the rate for which it was designed.
14) Don't Overreach - Keep proper footing and
balance at all times.
15) Stay Alert - Watch what you are doing.
Use common sense. Do not operate
appliance when you are tired.
16) Disconnect Appliance - Disconnect the
appliance from the power supply when not
in use, before servicing, when changing
accessories such as blades, and the like.
17) Store Idle Appliances Indoors - When not in
use, appliances should be stored indoors
in dry, and high or locked-up place - out of
reach of children.
18) Maintain Appliance With Care - Keep
cutting edge sharp and clean for best
performance and to reduce the risk of
injury. Follow instructions for lubricating
and changing accessories. Inspect
appliance cord periodically, and if
damaged, have it repaired by an authorized
service facility. Inspect extension cords
periodically and replace if damaged. Keep
handles dry, clean, and free from oil and
grease.
19) Check Damaged Parts - Before further use
of the appliance, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other condition that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
Leaf mulcher
Table 57.1 minimum gauge for extension
cords
Volts
120V
25
240V
50
Ampere Rating
More than Not more
than
0-6
18
6-10
18
10-12
16
12-16
14
NOTE-Only the applicable parts of the Table need to be
included. For instance, a 120-volt product need not include
the240-volt heading.
Figure 57.2
method of securing extension cord
APPLIANCE CORD
CORD
SET
(a) Tie cord as show
(B) Connect plug and receptacle
ADDITIoNAL sAFETY
rULEs For LEAF MULCHEr
warNiNg! The leaf mulcher is
designed to shred leaves, grass
clippings, pine needles etc, it can not be used
to shred branches, sticks or brush.
1. Become familiar with all sections of this
owner's manual before attempting to
operate the leaf mulcher. This leaf mulcher
should be used solely for the purpose it
was intended.
2. Use only parts or accessories specifically
Total length of cord in feet
50
100
150
100
200
300
AWG
16
16
12
16
14
12
16
14
12
Not
12
recommended
EN
9
9
Publicité
