Publicité
Les langues disponibles
Les langues disponibles
package).
1) Use two screws and wing nuts to connect
both ends of the bag support ring. Place the
hardware in a position that allows the bag
support ring to best fit the paper bag you are
using (See Fig I).
2) Insert the bag support ring in the bag just
below the fill line. (See Fig J)
3) Fold the paper bag inside along the fill line
of the bag. (See Fig K1,K2)
5. FiTTiNg a CoLLECTioN Bag
1). When using a paper bag with support ring,
place the bag into the stand from the top. (See
Fig L1)
2). If you use a plastic collection bag, roll it
over the top of the stand like you would with
trash bag being used on a trash can. (See Fig
L2)
6. rEmoviNg a FuLL CoLLECTioN Bag
1). When the bag is full, turn off the mulcher
then unplug it. Lift the mulching power head
from the stand.(See Fig. L3)
2). Lift the stand off of the collection bag from
12
12
the top. (See Fig.L4)
oPErATIoN
1. oN/oFF SwiTCh
The ON/OFF switch is located on the lower
side of the motor housing portion of the
power head. To turn on, pull out the switch.
(See Fig.M1)
To turn off, push the switch in. (See Fig.M2)
CauTioN: To prevent exposure to
dusty warm air don't stand in front
of the motor ventilation slots.
2. LoaDiNg Your maChiNE
With the mulcher running, feed double
handfuls of dry leaves, or single handfuls of
wet leaves, into the funnel. Allow the machine
to shred the load completely and regain speed
before inserting the next handful. Do not
overload the machine by letting it labor at low
speed: this may cause the motor to stop. If
this happens, turn the switch off, unplug the
machine, clear the unshredded material from
the funnel, restart the machine, and continue
Leaf mulcher
with your shredding.
warNiNg! Filling mulcher with
unshredded material at a rate faster
than the machine can handle may result
in permanent damage to your motor.
always wear protective glasses and a
mask.
MAINTENANCE
1. CLEaNiNg Your uNiT
Your unit requires a minimum of maintenance
other than cleaning. It is recommended that
you clean out built –up residue inside the
housing area during and after each use. When
fully disassembled, clean the funnel cover
and funnel with clean water, while using a
dry cloth to clean the motor housing. Replace
cutting line as often as necessary and clean
air filter frequently. Any other maintenance or
repairs should be performed.
CauTioN: Directly cleaning the
motor housing with water will lead
to permanent damage to the motor.
2. rEPLaCEmENT oF CuTTiNg LiNE
(See Fig. N)
Replace cutting line (e) when a noticeable
decrease in shredding efficiency in observed.
To remove used cutting lines, cut the old lines
and pull the remaining line out of the spinner
head (f). When installing new cutting lines
place each end of the new line through the
two holes in the post on top of the spinner
head and through so that both ends of the line
are even. Then thread the lines through each
corresponding ferrule so that both ends of
the line are even. Note: there is a built in line
cutter that will cut and trim lines shortly longer
than desired.
warNiNg! For optimum
performance use only worX
branded replacement lines. aftermarket
monofilament lines having max
diameter of 0.09'' (2.1mm) diameter
maximum length of 13.8" long could be
temporarily substituted. use of thicker
lines, lines made of substitute material,
or lines greater than 13.8" long may
EN
Publicité
