Safety Instructions; Led Light - Eurotops 45652 Mode D'emploi

H 1506 /
KV1505RL
Warning: Please read this instruction manual carefully before using the instrument and keep it for future use.
A. SAFETY INSTRUCTIONS
1. The device is intended exclusively for private and not for commercial use. Only use this device as describe in this instruction
manual.
2. Do not use outdoors.
3. Keep it away from heat sources such as radiators, to avoid deformation of plastic parts.
4. Do not use coarse or abrasive sponges/cloths or steel wool to clean the appliance.
5. This unit is not designed to be operated by means of an external timer or a separate remote control system.
B. HOUR SETTING
1) Insert 1 AA batterie observing the correct polarity indicated.
2) Start working
1. Automatic mode
As soon as you insert the batteries, automatic reception will be activated
and search the RCC signal. Time will be set automatically.
DCF signal
This clock is designed to set itself automatically on reception of the radio
signal coming from close to Frankfort in Germany. It allows all European
country within approx. 1500 kms radius around Frankfort to benefit
from this radio signal. Summer and winter time settings will be also
automatic.
All is set by this radio signal which is received by the clock several times
a day.
DCF signal reception
The unit starts searching for the DCF signal automatically after been start up. This operation can take several minutes to several hours.
Please do not hesitate to change of room for the first reception. The unit automatically adjusts depending on the signal every day at 2
o'clock, 3 o'clock, 4 and 5 o'clock, 14 o'clock, 15 o'clock, 16 o'clock, 17 o'clock.
2. Hand setting (if RCC signal is out of reach)
If RCC signal is out of reach it is necessary to set the time manually.
Push the « SET » button (button n°3) during 5 seconds and keep pushing until the time is correct. Once you reach the time you want,
release the «SET » button.
Without any action during 8 seconds, the clock will exit the hand setting mode.
3.Back to automatic mode
Push the « REC » button (button n°2) to come back to automatic mode. Automatic reception will be activated and clock will search RCC
signal. Time will be set automatically.
4.Reset
To reset clock, push with a small spike on « RESET » button (button n°1).
C. LED LIGHT
Insert 3 AA battery observing the correct polarity indicated.
Then you can choose 1 of the 3 modes :
RADIO-CONTROLLED WALL CLOCK EN