Electronic Speed Controller (Esc) - ARMA 4x4 4S Mode D'emploi

ND
Motor wires x 3
Power Switch & Set button
Input Voltage
Throttle
Setup
1. Throttle trigger in neutral
position - press set button (1
Green flash)
OM

Electronic Speed Controller (ESC)

Only use fully charged LiPo batteries (4.2V per cell) to prevent
battery/ESC damage.
IC5™ Battery Plug
3S-4S LiPo (11.1-14.8v)
35C 5000mAh Minimum
Connect batteries, turn on transmitter and then press/hold the set button 'A' whilst
turning on the switch on 'B' and release the set button when the RED light flashes
on the ESC.
2. Throttle trigger in full throttle
position- press set button (2
Green flashes)
4. Switch off ESC to complete setup
ESC Specifications
15
IC5™ Loop Wire
WARNING: Heat sink
may be hot after use.
Receiver Plug (CH2)
BEC Output 6.0v/6A Max
3. Throttle trigger in full brake
position - press set button (3
Green flashes)
A
WWW.ARRMA-RC.COM
B