RIP TUNES RACR-400 Mode D'emploi page 8

Playing Music from the Cassette Tape Player
1. Open the Cassette Tape dock (4) by pressing the Cassette Tape
STOP/EJECT button (9)
2. Insert the cassette tape
3. Push the Casette Tape dock closed until it clicks
4. Move the Mode Switch (12) to the Tape position
5. Press the Cassette Tape PLAY button (6) to begin playback
6. Use the Volume Control (2) to adjust to the desired listening
level
7. Press the Cassette Tape PAUSE button (10) to pause playback
or the Cassette Tape STOP/EJECT button (9) to stop playback
Skipping Songs When Using the Cassette Tape Player
To skip to the next or previous song:
1. Press the Cassette Tape STOP/EJECT button (9)
2. Press the Cassette Tape FFWD button (8) or the Cassette Tape
REW button (7)
3. Once you've reached the desired play location, press the Cas-
sette Tape STOP/EJECT button (9) again
4. Press the Cassette Tape PLAY button (6)
Pairing and Playing through a Bluetooth Device
As mentioned before, you can also connect and play music from
Bluetooth devices or by either connecting a USB cable/device or
inserting an SD/MMC memory card.
1. Enable Bluetooth on the device you are connecting for play-
back (Refer to your device manufacturer's instructions)
2. Move the Mode Switch (12) to the Bluetooth Music position (for
BT/USB/SD)
3. Press the Bluetooth Music button until the BT Indicator Light
blinks to indicate it is in pairing mode
4. On your Bluetooth device, perform a Bluetooth device discov-
ery to add the RACR400 as a new connected device
5. When the Bluetooth device is discovered, it will display
"RACR400" in its Bluetooth menu. If your device asks for a
8