Booster PAC ES400 Manuel De L'utilisateur page 6

OPERATING INSTRUCTIONS
Used as a USB Power Supply
Your jump starter can be used to power or recharge a wide variety of small electronic
devices.
1. Connect your device's charging cable to the device.
2. Connect the USB end of the charging cable into the USB port on the jump starter.
3. Press the Status/Power Button on the front of the unit to activate USB charging.
Used as a 12VDC Power Supply
Your unit can be used to power a variety of 12VDC accessories using a 12V Adapter
(included with Model No. ES580, available as an optional accessory for Model No.
ES400).
1. Connect the male plug from your 12V device to the 12V female adapter.
2. Connect the pin jack at the end of the 12V female adapter cord to the output port
marked "DC Output."
3. Press the Status/Power Button on the front of the unit to activate the unit.
Used as a Flashlight
To turn on the LED Flashlight, first power the unit on by pushing the POWER/Status
button. Then, press and release the light button. Successive pushes of the button will
change the light pattern from solid to strobe to SOS to off.
Used as a 12 Volt Jump Starter
Note: For optimum performance, do not store your Jump Starter below 50°F when using
as a jump starter. Never charge or jump start a frozen battery.
Note: When using as a jump starter, it is recommended that that the unit be at or near
100% state of charge as indicated on the unit's display.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eyewear when working near batteries.
3. Review this instruction manual and the instruction/safety manual provided by the
manufacturer of the vehicle being jump started.
4. Connect output cables/clamps to the jump starter through the covered jump
starting port. Be sure that the cable connection is fully engaged and secure. Once
the smart cable/clamp is connected to the unit, the status LED on the smart cable/
clamp will light red.
5. Turn ignition off before making any vehicle connections.