Jenn-Air W10418360A Instructions D'utilisation page 10

OPTION SELECTIONS
OPTIONS
Runs the dishwasher at a
later time or during off-
peak electrical hours.
Select a wash cycle and
options. Press 4 Hour
Delay. Press START/
RESUME. Close the door
firmly.
NOTE: Anytime the door is
opened (such as, to add a
dish), the START/RESUME
button must be pressed
again to resume the delay
countdown.
Control Lock Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The Control
Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button
while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the
controls are locked.
or
To turn off Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The light
turns off.
NOTE: If your model requires you to press and hold 4 Hour Delay to lock the controls, the Control Locked LED will be
on or off to indicate if the Control Lock is active or not.
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE
To start or resume a
wash cycle
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
To turn the audible
tones on or off.
10
CAN BE WHAT IT DOES
SELECTED WITH
Available with Delays the start of a
cycle up to 4 hours
any cycle
COMMENTS
If the door is opened during a cycle or the power is interrupted, the START/RESUME
indicator flashes. The cycle will not resume until the door is closed and START/RESUME is
pressed.
NOTE: If the START/RESUME button is located on top of door, push door firmly closed
within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
the start button LED will flash, an audible tone will be heard, and the cycle will not start.
Press CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle After Dishwasher Is Started" and "Changing a Cycle After
Dishwasher is Started" sections.
Press and hold the Super Scrub button for 3 seconds to turn the audible tones on or off.
Only audible tones for confirming button presses can be turned on/off. Important audible
tones, such as indicating a cycle has been interrupted, cannot be deactivated.
ADDED TIME TO CYCLE
TYPICAL MAX
240 240
.
ADDED
WATER
GALLONS
(LITERS)
0