Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning.
General inspection
•
Regularly check that all the fixing screws are tight
•
Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised GMC service centre. This advice also applies to extension cords
used with this tool
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves when cleaning
this tool.
•
Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the device's service life
•
Clean the body of your machine with a soft brush, or dry cloth
•
Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild detergent
on a damp cloth is recommended
•
Water must never come into contact with the tool
•
Ensure the tool is thoroughly dry before using it
•
If available, use clean, dry, compressed air to blow through the ventilation holes (where
applicable)
Lubrication
•
Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Brushes
•
Over time the carbon brushes inside the motor may become worn
•
Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
•
If you suspect that the brushes may be worn, have them replaced at an authorised GMC service
centre
Storage
•
Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and
are not viable for repair.
•
Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
•
Contact your local waste disposal authority for information on the correct way to dispose of
power tools
10
GB
Publicité
Table des Matières
