Explanation Of Functions - Babyfon BM 880 ECO Mode D'emploi

GB
Using your Babyfon
1. Attach the neck strap to the parent device.
2. Make sure that both devices are switched on and that the same channel is selected.
3. Set the response sensitivity of the microphone on the baby device to the level you
require. To begin with, we recommend a middle position that can later be adjusted
as required.
4. Set the volume on the parent device to the level required (high / medium / low). If
the baby device is activated by a noise in the baby's bedroom, transmission starts
automatically and the power-on lamp of the parent device changes from green to red
for the duration of the transmission.

Explanation of functions

Reception control indicator / reception monitoring
There is regular radio contact between the baby device and the parent device. The
reception control indicator on the parent unit indicates whether there is still sufficient
contact to the baby device. All 4 lamps glow during full reception; only one lamp glows
when reception is weak. If radio contact breaks down completely, for example because
the baby device is outside the range, or because the batteries in the baby device are
empty, the parent device emits an alarm tone after a short time. In addition, the power-on
lamp flashes. The alarm tone and flashing stop automatically as soon as radio contact is
resumed.
Digital pilot tone / preventing interference
Besides the sounds made by the baby, the baby device also transmits an inaudible signal
tone. The parent device only begins reception when this signal tone is received. This prac-
tically rules out the reception of external wireless baby monitors. In rare cases, however,
interference from other wireless devices in the vicinity may occur. In the event of such
interference or poor reception, switch both devices to the other channel.
250 m range
In ideal conditions, the range of your Babyfon outdoors is approx. 250 metres. Obstacles
such as walls, ceilings or large objects affect the range. The more obstacles there are
between the baby and parent devices, the smaller the range becomes.
Using the battery pack supplied
Parent device
1. Open the battery compartment by loosening the screw on the battery compartment lid.
12
GB
2. Insert the battery pack supplied in the battery compartment, observing the correct
polarity. Make sure that the charging contact has been made in the battery
compartment (see B20 on parent device).
3. Slide the battery compartment lid back on to the battery compartment and tighten
the screw again.
4. Connect the AC adapter to the connector on the charger for the parent device. Place
the parent device in the charger so that the charge contacts of the parent device and
the charger are connected.
5. The battery pack is now charged automatically. Charging is complete after approx. 15
hours.
Baby device (battery pack not included)
The battery pack supplied can only be used for the parent device. You can order a battery
pack for the baby device (Babyfon® model number EAB 4) from a specialist dealer. This
can then also be charged using the charge function integrated in the baby device.
Using other battery packs or batteries
The parent and baby devices can also be powered with standard AAA battery packs or
non-rechargeable 1.5V AAA batteries. However, standard AAA battery packs cannot be
charged using the devices.
Battery alarm
A signal tone and the flashing power-on lamp warn you as soon as the battery pack or
batteries in the parent device are empty. You should then insert new batteries or recharge
the battery pack.
Disposal of batteries
Consider the environment when disposing of the batteries or battery packs, which must
not be thrown away with domestic rubbish. Do not use old and new batteries or different
battery types simultaneously. Remove batteries from the device if it is not to be used for a
long time.
Specifications
No. of channels: 2
Frequency 864.8 – 865.0 MHz
Power supply: Transmitter:
Receiver:
Transmitting power: max. 10 mW
Operating temperature: 10 to 40° C
Subject to alteration.
Babyfon® is a registered trademark of Vivanco AG, Ahrensburg
AC adapter plug 9 Volt/ 200mA
or 4 AAA batteries or
EAB 4 battery pack (available
from specialist dealers)
AC adapter plug 9 Volt/ 200mA
or battery pack EAB 2 (included)
13