Appliance Handling Safety; Safety Codes And Standards; Electrical Safety - Thermador ME301YP Guide D'installation

IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
When installing a cooktop over a single
¡
oven, be sure to follow the instructions in
both the oven's and the cooktop's installa-
tion manuals.
Never modify or alter the construction of
¡
the appliance.
For example, do not remove leveling
▶
legs, panels, wire covers or anti-tip
brackets/screws.
Risk of suffocation
WARNING ‒ Risk of suffocation!
Remove all tape and packaging before us-
ing the appliance.
Destroy the packaging after unpacking
▶
the appliance.
Never allow children to play with pack-
▶
aging material.

Appliance handling safety

Follow these instructions when moving or han-
dling your appliance.
Risk of injury
WARNING ‒ Risk of injury!
Unit is heavy and requires at least
two people or proper equipment to move.
For double and triple ovens, three or
▶
more people are needed to assist with
lifting the unit into place.
Do not lift appliance by door handle.
▶
Remove the door for easier handling
▶
and installation. See instructions in this
manual.
Risk of cutting
WARNING ‒ Risk of cutting!
Hidden surfaces may have sharp
edges.
Use caution when reaching behind or
▶
under appliance.

Safety codes and standards

This appliance complies with the latest version
of one or more of the following standards:
CAN/CSA C22.2 No. 61 - Household Cook-
¡
ing Ranges
CSA C22.2 No. 64 - Household Cooking
¡
and Liquid- Heating Appliances
UL 1026 - Electric Household Cooking and
¡
Food Serving Appliances
UL 858 - Household Electric Ranges
¡
It is the responsibility of the owner and the in-
staller to determine if additional requirements
and/or standards apply to specific installa-
tions.

Electrical safety

Follow these safety instructions to avoid risk
by electric shock.
Installer - show the owner the location of the
¡
circuit breaker or fuse. Mark it for easy refer-
ence.
If required by the National Electrical Code
¡
(or Canadian Electrical Code), this appliance
must be installed on a separate branch cir-
cuit.
Local codes vary. The installer is responsible
¡
for ensuring that the installation, connec-
tions, and grounding comply with all applica-
ble codes. The manufacturer is not responsi-
ble for any issues associated with the im-
proper installation of this product.
Refer to the rating plate for more informa-
¡
tion.
→ "Rating plate location", Page 15
Risk of electric shock
WARNING ‒ Risk of electric shock!
Before you turn on power supply, make
¡
sure all controls are in the OFF position.
ELECTRIC SHOCK HAZARD
¡
Disconnect power before installing or
▶
servicing. Before turning power ON, be
sure that all controls are in the OFF po-
sition.
DO NOT remove connections.
▶
DO NOT use an extension cord.
▶
en-us
5