Door; Drying The Washing Correctly - Saivod Electron Dry Mode D'emploi

GB
The drier is the front-loading type. Pull the handle outwards, without forcing it, and gently open the door.
The appliance will stop if the door is opened during a drying cycle. The drum will continue to rotate for a
while, slowing down gradually to a stop.
Important:
Obviously, during a drying
cycle the washing in the drum
will be hot. The washing is
cooled during the cooling
cycle (Last 4-5 minutes of
each cycle).
To avoid being scalded by
Follow the procedure below:
A
Spin the washing.
B
Separate the items into types or
fabrics.
Close any zips and fasten buttons
and remember to empty the pock-
ets of any clothing.
Turn jumpers inside out.
C
Open the door
Load the washing in the drum and
remember to load sheets from a
corner first.
It is advisable to load small and
large items together.
D
Close the door
Dry your hands (never touch elec-
tric appliances with wet hands).
Make sure that the ON/OFF but-
ton is OFF.
Insert the plug in the mains
socket.
E
Make sure that the programmer
In the case of doubt as to the type of fabric, read the label on the item itself. Almost all items that can be
machine dried have this information specified on the label. To avoid static electricity being generated in
the items, add a conditioner to the rinse cycle of the washing machine.
Remove synthetic materials from the drum immediately to prevent them from creasing.
USING THE APPLIANCE
steam or burned by the hot
washing, pay particular atten-
tion when opening the door
during the drying phase.

DRYING THE WASHING CORRECTLY

is positioned on "STOP", press
the ON/OFF button and, after the
audible signal, set the required
program. (see program table)
At this point, the appliance will
start and the indicator light will
stay on.
IMPORTANT:
- When you want to change the
programme being used;
- When you want to add some
items after the drying cycle
has already started;
- When, for whatever reason,
there is an electric power cut-
out during drying cycle;
In order to re-start the machine,
position the knob on STOP,wait
for the light to stop flashing and
then reset the programme re-
quired.
At the end of the drying cycle, if
the selector is not turned on STOP,
or if the ON/OFF switch is not po-
sitioned on OFF, the machine will
automatically perform an anti-
PRECAUTIONS FOR FABRIC TYPES

DOOR

12
crease cycle with simultaneous
acoustic signalling.
F
After having removed the dry
washing, clean the filter as fol-
lows:
- Lift the filter
- Open it and clean it using a
soft brush
- Close it and replace it in its
seating
- The filter must be washed
periodically using soapy wa-
ter in order to remove very
small particles.
Unplug the appliance from the
mains supply.