Cleaning And Maintenance; Technical Data - Adler europe AD 7714 Mode D'emploi

USSING
1. Press the main switch on the right side of the device - Picture B to switch the device on and off.
2. The device is now in standby mode. Press the on / off button (1) on the remote control - Picture C.
3. Press the MODE button (2) in turn to select the operating mode:
- 1000 W the device will constantly heat up with 1000 W.
- 2000 W, the device will constantly heat up with 2000W.
- Auto mode, press the + and - buttons to manually set the temperature. The device will automatically enter the temperature maintenance
mode.
- Open window detection function - When this function is selected, the device will automatically turn off the heating if the room temperature
drops suddenly by 10 ° C.
4. To turn off the device, press the on / off button (1) on the remote control. The device cools down and turns off after about 30 seconds.
SETTING THE INTERNAL DEVICE CLOCK
NOTE: If you do not set the current time and day of the week, the device will not work properly because it will operate according to its own
internal clock, which is incorrect.
1. Select the AUTO function using the MODE button.
2. Before setting the timer, set the day of the week and the current time:
- Press the DAY button and select the current day using the + and - buttons. Wait until the display stops flashing.
- Press the CLOCK button and set the current time using the + and - buttons. Wait until the display stops flashing.
- Press the MIN button and set the current minutes using the + and - buttons. Wait until the display stops flashing.
TIMER PROGRAMMING SETTING - TIMER
This function allows you to program the time to turn on and off the device on each day of the week at the desired time.
The timer can only be set after selecting the AUTO function and setting the device's internal clock.
1. Press the WEEK / TIMER button and select the day of the week on which you want to set the device to switch on and off automatically
using the + and - buttons. Wait until the display stops flashing.
2. After pressing the SET UP button, the ON symbol will light up in the display. You can now set the timer start time. Use the CLOCK, MIN,
+ and - buttons to set the timer start time. Wait until the display stops flashing.
3. After pressing the WEEK / TIMER button (6) again and then pressing the SET UP button, the OFF symbol will light up in the display. You
can now set the timer off time. Wait until the display stops flashing.
NOTE: the start time must always be lower than the stop time.
NOTE To reset the timer to default settings, press the RESET button.
V. CLEANING AND MAINTENANCE
1. Always unplug the appliance from the power socket before cleaning.
2. If during cleaning items such as the power plug, thermostat thermostat electrical contacts etc. are soaked before being used
again, they should be thoroughly dried
3. Do not use aggressive detergents in the form of emulsions, lotions, pastes, etc. to clean the cabinet. They can, among other
things, remove the information graphic symbols, such as signs, warning signs, etc.
4. Ensure that the device has cooled down before cleaning.

TECHNICAL DATA:

Voltage: 220-240V ~50/60Hz
Power: 2000W Max. Power: 2200W
Ip20
DO NOT COVER« INSCRIPTION IMPORTANCE
The inscription on the device means that the device is not to be covered with clothing, blankets and other textile
products which could cause ignition.
WARNING: Do not use this equipment near bathtubs, showers, swimming pools and similar
water tanks.
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins.
Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may effect the
environment. Do not dispose this appliance in the common waste bin.
"Caution Hot Surface" - The temperature of available surfaces may be higher when the
equipment is working, which means that the housing elements become very hot during
operation during operation, SAVE CAREFUL !!!
8