Electrical Supply - Empire Comfort Systems OLL60FP12S-1 Instructions D'installation Et Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

FIREPLACE FRAMING AND INSTALLATION

All wiring should be done by a qualified electrician and shall be

in compliance with all local, city and state building codes. Before

making the electrical connection, make sure that the main power

supply is disconnected. The fireplace, when installed, must be

electrically grounded in accordance with local codes, or in the

absence of local codes, with the National Electrical Code ANSI/

NFPA 70 (Latest Edition).

Wiring to the junction box must be metal clad or enclosed in a

conduit and must be approved for outdoor use. A connector for

the junction box to accommodate 1/2-in. conduit is supplied in the

instruction envelope. The fireplace receptacle must be connected

to an external GFI protected outlet installed near the fireplace

See Figure 17.

Route the wiring from the external GFI outlet through the conduit

to the junction box. Leave approximately 6-in. of wire in the junc-

tion box for connection.

Retrieve the receptacle and cover from the instruction enve-

lope. Attach the black wire to the gold screw and white wire to

the silver screw of the receptacle. The ground wire should be

attached to the green ground screw on the junction box and the

receptacle.

Place receptacle in position and attach cover plate. Make sure

the cover plate doors open upward. Be sure to test the receptacle

to ensure the GFI circuit functions properly. Plug transformer

power cord into receptacle, and close the unused receptacle

door.

Page 16