Sub Function (Wired Remote Controller)-Electric Heater - LG PREMTB10U Manuel Du Propriétaire

Operating Instructions

Sub function (wired remote controller)-Electric Heater

It is a function to strengthen the heating ability by turning on the electric heater during the heating operation.
It can only be set during heating operation.
• Heater function is an additional function and operates only on models installed with Electric
heater. The heater must be LG made and has to be purchased separately. (Model:ANEH053B1,
ANEH103B2).Contact LGE for the same.
• The remote control will automatically displays ! icon when this additional heater function is turned on.
• This emergency heater can be turned on for heating operation during the cooling mode. For this
operation the particular indoor unit must turned off to ensure the heating process. (By this the
simultaneous heating and cooling can be achieved)
• This emergency electric heater can be "turned on" during the display of error code. During this
emergency operation the heater icon will be displayed along with error code as shown below.
* Exceptional case : Error code 1,3,9,10.
* If the previous mode of Indoor unit is COOL,DRY or FAN ONLY mode, the heater must be turned on manually.
• When only VAHU is on a electric heater and the other IDU is on cooling mode, Central-Controller
displays Air Circulation and cannot control temperature, airflow and etc. If users input any order with
Central-Controller, VAHU stops being on a electric heater. And if users input heating mode with
Central-Controller, different operation mode may occur. So please select same mode with the others.
(Central-Controller : Simple Central Controller, AC Smart, Option Kit & 128 Units Expansion Kit, ACP & AC Manager Plus)
NOTICE
For detailed operational setting please refer wired remote controller manual.
8 Vertical Air Handling Unit
Repeatedly pressing
1
until icon flash.
Turn on/off electric heater by
2
pressing button (the
will be displayed in case of
setting option and disappear in
reverse case .)
Press button to exit.
3
❈ After setup, it automatically
gets out of setup mode if there
is no button input for 25
seconds.
❈ When exiting without pressing
set button, the manipulated
value is not reflected.
button
icon