Door Height Adjustment - Saba SBS525WDIL Manuel D'utilisation

Door Height Adjustment

If the doors of the appliance are not aligned then
the height of them can be adjusted, if required
please follow the below steps.
Note: The maxi um height adjustment is 5mm
Rotate the locking nut clockwise (as shown in
the diagram below) with a wrench for 2 full
rotations to loosen it. You can now rotate the
adjusting nut (as shown in diagram below) to
GB raise or lower the height of the door. Once the
door is set to your desired position, then tighten
the locking nut by rotating it anti-clockwise.
Fixed shaft
Not level
Leveling feet
Locking nut
When the fridge door is low:
Open the door, use a wrench to rotate the
adjusting nut anti-clockwise to raise the height
of the door. Once the doors are aligned, then
tighten the locking nut by rotating it anti-
clockwise.
GB-16
Adjusting nut
Right
Wrench
When the fridge door is high:
Open the door, use a wrench to rotate the
adjusting nut clockwise to lower the height of
the door. Once the doors are aligned, then
tighten the locking nut by rotating it anti-
clockwise.
If «OK» is not displayed, the average
temperature in this area will be very high.
You ought to adjust the thermostat to a
colder setting.
For every modification of your thermostat, you
are supposed to wait for the stabilization of the
temperature inside the unit before proceeding,
if necessary, to a new setting. Do change the
position of the thermostat gradually and wait
at least 12 hours before re-checking.
GB
GB-17