Publicité
Les langues disponibles
Les langues disponibles
1 4
Standard instructions
with factory pre-setting
1) How to make a cup of coffee?
• Put your cup under the two pour spouts (D).
• Fill the water tank.
• Put the pouch containing the coffee into the
pouch holder marked (
position it correctly in the opening intended for
it (flat and well centred) (F).
• Put the pouch holder back in the device (G).
• Screw sufficiently tight by turning the appro-
priate handle (H) to the right. If this is not
done correctly, the T
• Press the button (J) or (K).
• After the lapse of a few seconds required to
heat the water, the pump is triggered and your
coffee flows into the cup.
• Once the coffee has been poured, unscrew the
handle (H) before removing the full cup to
ensure that the water does not stay in the
pouch holder and to remove the air from the
pipe.
2) How to make an expresso?
Follow the same stages as those described
above, but select the pouch holder intended
for the pods (the deepest) marked with the
emblem.
3) How to make a cup of tea?
Follow the same stages as those described
above, but select the tea or coffee pouch holder
marked with the drawing of the tea leaf.
4) How to make a cup of soup or hot chocola-
te?
• Pour the sachet of soup or chocolate into a
cup.
• Place the cup under the two pour spouts (D).
• Fill the water tank.
• Insert the pouch carrier marked with the
emblem into the device.
• Screw sufficiently tight by turning the appropria-
te handle (H).
• Press button (J) or (K) so that the water starts
to flow into the cup.
• Once the coffee has been poured, unscrew the
handle (H) before removing the full cup to
ensure that the water does not stay in the
pouch holder and to remove the air from the
pipe.
Instructions with customised regulation
1) How to programme the desired quantity of
water in each cup?
• Put one cup under the two pour spouts (D).
• Fill the water tank.
• Put the tea or coffee pouch containing the cof-
), taking care to
will not work.
EACOF
fee or tea in the tea or coffee pouch holder (F).
• Put the tea or coffee pouch holder back in the
device (G).
• Screw sufficiently tight by turning the appropria-
te handle (H).
• Push the chosen button (J), and keep the but-
ton down until the coffee or tea flows into the
cup and reaches the desired level. The T
has now memorised the desired quantity of
water for each of the following cups of coffee
or tea, as long as you always press the same
button.
You can change the programming at any time by
performing these operations over again.
As there is a second button, you can programme
two different doses.
For example, one for tea and the other for cof-
fee, or one for expresso and the other for soup
or one for you and one for your spouse, depend-
ing on how you like your tea or coffee.
2) How to make a "long" coffee or tea
without touching the pre-established regu-
lations
• Put one cup under the two pour spouts (D).
• Fill the water tank.
• Put the tea or coffee pouch containing the
coffee or tea in the tea or coffee pouch hol-
der (
) or (
• Put the tea or coffee pouch holder back in the
device (G).
• Screw sufficiently tight by turning the appro-
priate handle (H).
• Press one of the buttons (J) or (K) then relea-
se immediately.
• Allow the coffee or tea to flow to the pro-
grammed level.
• Push button (J) or (K) once again to trigger a
second flow of water.
• When the desired quantity has been reached,
press the same button once again (J) or (K) to
stop the flow.
3) How to make a small, strong coffee,
without changing the programmed regula-
tions?
• Put a cup under the two pour spouts (D)
• Fill the water tank.
• Put the coffee or espresso pouch in the
pouch holder marked (
• Put the pouch holder back in the device (G).
• Screw sufficiently tight by turning the appro-
priate handle (H).
• Press buttons (J) or (K) then release immedia-
tely.
• Allow the coffee or expresso to flow to the
desired level.
• Push the same button (J) or (K) again to stop
the flow when the desired quantity is obtai-
ned.
EACOF
) (F).
) (F).
Publicité
