weasy IRO320 Mode D'emploi page 8

Steps
1. Set the height needed. To do this, open the screw (4), pull out the
telescopic rod (3) and then close the screw (4) again
3. Pull the garment which is to be pressed over the nylon balloon and the hanger (2) and do up
the buttons if necessary. Make sure that
a. the collar is fitted over the collar section (1) on the hanger (2),
b. any button strip is over the hole line on the nylon balloon,
c. the arms of the nylon balloon fit properly in the sleeves of the garment and are not
twisted or scrunched up,
d. all buttons on the garment (including on the sleeves) are done up.
4. Insert the mains plug into an easily accessible socket.
5. Press the + or – buttons of the timer (8) and set it to the length of time you want.
6. Once the nylon balloon has inflated, straighten out the garment and smooth it down again.
7. Spread the clamps along the bottom of the garment (at the front and back in each case on
the outsides and in the middle on the button strip at the front) so that it is weighted down
and will not go out of shape when the nylon balloon is inflated.
8. When the set time elapses, the device switches off automatically. The drying / pressing
process can be interrupted at any time by turning the timer (8) off.
9. Remove the garment from the nylon balloon and hanger (2).
10. Pull the mains plug out of the plug socket and allow the device to cool down completely.
Tips
• The device is intended primarily for machine-spun laundry! If hand-washed or non- machine-
spun laundry is to be ironed, first allow it to dry out a little first.
• The drying / ironing process takes around 10 minutes for a spun-dried shirt. However, the length
of time can vary depending on the material and thickness of the material. We recommend that
you start with a shorter time and extend it if necessary.
• The nylon balloon can be enlarged or reduced in size with the aid of the zip fasteners. For smaller
sizes, the zip fasteners should be closed. For larger sizes, the zip fasteners should be opened
on both sides.
• Wide-apart buttons may result in the button strip crimping slightly during ironing. Here it is
advisable to smooth down the button strip again by hand immediately after the pressing
process.
2. If you have not already done so, pull on the
nylon balloon (see the "Before Initial Use" chapter,
"Assembly" section). The nylon balloon should sit
immediately below the mounting flange (6) so that
it can fully inflate.