Uline H-1027 Instructions D'utilisation page 9

PUSHER SPRING REPLACEMENT
1. Loosen the screws and nut with a 8 mm spanner
wrench and a 4 mm Allen wrench. (See Figure 21)
2. Remove the magazine assembly. (See Figure 22)
3. Pull the pusher back until it stops on the rod, then
rotate the pusher to position. (See Figure 23)
4. Push the magazine seat back and remove it from
the magazine.
Figure 21
Figure 24
PAGE 9 OF 33
OPERATING INSTRUCTIONS CONTINUED
Figure 22
Figure 25
5. Loosen the screw and nut with a 2.5 mm Allen
wrench and 7 mm socket wrench. (See Figure 24)
6. Loosen the rod with a 6 mm offset wrench and
remove the pusher guides. Remove the pusher.
(See Figure 25)
7. Remove the spring pin with a hammer and 4 mm
straight rod. (See Figure 26)
Magazine
Assembly
Figure 23
Pusher
Guide
Figure 26
Pusher
Spring
Pin
0421 IH-1027