Loading The Stapler; Staple Leg Length - Uline H-1027 Instructions D'utilisation

LOADING THE STAPLER

1. Disconnect the air supply.
2. Pull the pusher back until it stops on pusher pivots.
Rotate pusher to position. (See Figure 1)
3. Insert 2 sticks of appropriate staples into the
magazine. Let the sticks slide forward to the front of
the magazine. (See Figure 2)
Figure 1

STAPLE LEG LENGTH

1. Loosen the set screw on the bottom with a 3 mm
Allen wrench. (See Figure 3)
2. Adjust L/S screw with a screwdriver to the desired
setting. (See Figure 4)
a. If you are using 3/4" staples set L up.
b. If you are using 5/8" staples set S up. (See Figure 5)
Set Screw
Figure 3
PAGE 3 OF 33
SAFETY INSTRUCTIONS CONTINUED
Pusher
L /S Screw
Figure 4
4. Pull the pusher back to an upright position and
gently let the pusher slide forward against the
staples. Do not let the pusher slide forward and strike
the staples at high speed as this may deform the
staples and damage the stapler.
Figure 2
3. Tighten the set screw on the bottom.
Figure 5
0421 IH-1027