LaserLiner ClimaData Stick Mode D'emploi page 16

6
Notes on the measurement process and on use
Long-term measurement
1. Connect ClimaData Stick to the PC
2. Download and backup any existing data. Starting or configuring
a new measurement deletes all existing data.
3. Configure recording in the Setup menu (see section 4) and save the settings
4. Depending on your start parameter, position the device at the measuring
point and record measurements. Briefly press button 5 for „manual start".
5. The end of recording is reached when the memory is full or the recording
is stopped by connecting and reading out the device.
6. Connect ClimaData Stick to the PC, download and backup data.
Real time measurement
1. Connect ClimaData Stick to the PC
2. Download and backup any existing data. Starting or configuring
a new measurement deletes all existing data.
3. Configure recording in the Setup menu (see section 5).
4. Recording starts when the settings are saved.
5. The data can be saved at the end of recording.
!
Position the device upright to ensure sufficient air circulation
around the sensor. Use the supplied wall bracket.
If the device has been placed in a cold and/or very humid environment,
!
condensation may form in the sensor housing when it is removed due
to the change in climate. Position the device upright for a while to
allow it to acclimatise.
7 Download
To edit and document the recorded data, they must be transferred
to the software program. To do this, start the software and connect
the device to the PC vis USB interface.
!
Long-term measurements are saved as a PDF file on the stick.
Other data are not saved automatically.
16
EN