Base Installation Guide - Nikkei NH3214 Guide D'utilisation

II - Base Installation Guide
The Way Of Installing Base:
1. Please put the base on the desk as shown figure 1.
(the stand approximately 180 degrees from horizontal).
2. Put the hole of the base upright into shaft of unit(as shown figure 2).
3. Fix the stand and the screen with 4 screws (figure 3)
4. The rendering after installed (as shown figure 4).
The Way Of Unloading Base:
1. Please remove the screw between the base and shaft (as shown figure 1).
2. Left hand hold the cabinet of the unit,right hand hold the base then remove
the stand. (as shown figure 2)
EN-10