Radiatori 2000 PIANO II 600/3 Guide Rapide page 32

A)
CONNECT THE THERMOSTAT TO THE APP VIA BLUETOOTH
ATTENTION:
- Compatible systems for BLUETOOTH connection: iOS 10 or newer; Android 8 or newer;
- Devices NOT compatible with Bluetooth connection (recommended use of Wi-Fi only):
Huawei P8 / P9 / P10 and P8 / P9 / P10 lite, Huawei P20 Lite; Xiaomi Mi 6.
FOR BLUETOOTH CONNECTION
1. Enter the app and add a device as required on the screen in the Bluetooth section:
a. ANDROID system: immediately press the connection button on the thermostat
(active for about 90 sec). A flashing blue light will appear on the thermostat. Add
the device as required.
b. iOS system: the connection between smartphone and thermostat is immediate
without the need to press the connection button on the thermostat: it is sufficient that
the radiator is connected to an electrical power socket.
Add a device as shown on the Bluetooth screen.
If the connection is not successful, repeat the operation.
2. Add the radiator with the + ADD ONE button on the smartphone screen. Each radiator is
automatically entered with the name ONE. [Fig. 7]
3. Rename each radiator to the desired name by selecting it. (e.g. room radiator, bathroom
radiator, etc.).
4. Once you have registered all the radiators in your home, you can start checking each of them
by tapping the name of the chosen radiator.
PAIRING TO AN ADDITIONAL THERMOSTAT TO THE APP VIA BLUETOOTH:
1. Touch the settings symbol at the top right of the app home screen.
2. Select "ADD BLUETOOTH".
3. Repeat all the previous operations.
It is possible to associate multiple smartphone / tablet devices to the same app by downlo-
ading it to each device. However, it is possible to control the radiators with only one device
at a time.
B)
CONNECT THE THERMOSTAT TO THE APP VIA Wi-Fi
REQUIREMENTS FOR CONNECTION:
a) Check that GPS and LOCATION are ACTIVE on the smartphone / tablet;
b) Have the QR CODE supplied with the thermostat nearby.
FOR Wi-Fi CONNECTION:
1. Enter the app and go to the Wi-Fi area of the application [Fig. 16a];
2. Select ADD Wi-Fi [Fig. 16b];
3. Select ADD THERMOSTAT NOT YET CONNECTED TO HOME NETWORK [Fig. 16c];
4. Carefully read the controls proposed by the app for correct operation (e.g. Activate the Wi-Fi
of the smartphone / tablet);
5. Select GO TO SETTINGS;
6. Activate the Wi-Fi network;
7. Connect the device to the network rad_2000_wifi_xxxx.
31