Before You Begin - Emerson Micro Motion D Série Notice D'installation

BEFORE YOU BEGIN

About these instructions
This quick reference guide explains basic installation guidelines for all
®
Micro Motion Model D (except D600), DL, and DT sensors. For more
information about sensors, refer to the instruction manual that was
shipped with the sensor.
European installations
Micro Motion products comply with all applicable European directives
when properly installed in accordance with the instructions in this quick
reference guide. Refer to the EC declaration of conformity for directives
that apply to a specific product.
The EC declaration of conformity, with all applicable European
directives, and the complete ATEX Installation Drawings and Instructions
are available on the internet at www.micromotion.com/atex or through
your local Micro Motion support center.
INTRODUCTION
The sensor makes up one part of a Coriolis flowmeter. The other part is a
transmitter.
Installation options
Model D, DT, and DL sensors may be connected to the Micro Motion
transmitters listed in Table 1.
©2003, Micro Motion, Inc. All rights reserved. Micro Motion is a registered trademark of Micro Motion, Inc. The
Micro Motion and Emerson logos are trademarks of Emerson Electric Co. All other trademarks are property of their
respective owners.
2