GIESSE RC Mode D'emploi page 22

Wait state
If any of the 7 buttons is pressed when the radio remote control is in standby, it
awakens and enters the wait state. The display shows the channel (one of the 30)
selected before the radio remote control went into standby state.
Selection of the channel
To select a (new) channel, press the CH button; the displayed channel starts
flashing. Use the ▲(
channel, which flashes. By pressing the CH button again, the channel display
becomes steady-on.
If the newly selected channel is not activated by pressing the CH button, after a
standby or the next time the radio remote control passes to the wait state, the last
channel that was previously activated will appear on the display.
Storage of the M1 and M2 memory groups
The "sequence storage" state (M button) provides the possibility to assign two
distinct "memory groups", i.e., two memories. The storage is carried out as
follows.
Memory M1

Press the M button for 5 seconds to store the memory 1; the icon M1
appears flashing on the display.
Scroll through the channels using the ▲▼ arrows, and the various

channels will flash. To enter the channel in the memory, press the STOP
button, the channel stops flashing and becomes steady-on; carry out this
operation for all the channels you would like to store, up to a maximum of
10 channels.

To exit the channel storing mode, press the M button again for at least 1
second.

To erase the memory, go to the channel 00 and press the STOP button. After
the memory has been erased, all the channels start flashing. To exit, press
the M button again for 1 second.
Memory M2

Press the M button for 5 seconds, and the flashing icon M1 appears. Now
press the CH button and the icon M2 will appear flashing on the display.
Scroll through the channels using the ▲▼ arrows, and the various

channels will flash. To enter the channel in the memory, press the STOP
button, the channel stops flashing and becomes steady-on; carry out this
operation for all the channels you would like to store, up to a maximum of
10 channels.

To exit the channel storing mode, press the M button again for at least 1
second.
) arrow or ▼(
UP
) arrow buttons to select the desired
DOWN
22