Cleaning And Care - Westinghouse WSFS1009BK Manuel D'instructions

CLEANING AND CARE

WARNING: To avoid the risk of electric shock, always make sure
the product is unplugged from the mains outlet before cleaning
or servicing
1. The product should be cleaned and inspected on a regular
basis. Make sure the fan blade is clean at all times to prevent
damage and fading.
The fan can be cleaned in two ways:
a) Vacuum the fan blades or use a can of compressed air, or
b) Remove the front guard by removing the 6 screws securing
the grille to the fan (use a screwdriver with a magnetic tip).
2. To clean the front guard, turn counterclockwise to loosen the
screw and pull off the guard. To replace the front guard, align
the shaft with the inside groove on the guard and push inwards.
Screw the fastener on clockwise to tighten.
3. Take the guard off and wipe it with a cloth or use a can of
compressed air. Make sure the front guard is completely dry
before securing it back onto the fan.
4. Wipe the fan blades (do not remove) with a damp cloth dipped
in a light solution of water and mild detergent.
5. Make sure that water does not get into the motor while
cleaning.
6. The blade and rear guard (non-removable) must be completely
dry when the guard in place.
7. Do not use any chemical cleaners (e.g. acid or alcohol) to clean
the fan.
NOTE: This fan is not intended to be disassembled in order to
clean the internal parts (e.g. blade or motor). Disassembly may
damage the product. Never use liquids or abrasive cleaners to
clean the product.
EN
8
WSFS1009BK_2 in 1 High Velocity 10 Stand Floor Fan_2L.indd 8 5/12/2019 18:25:19