Adaptive Intelligent Recovery; Built-In Compressor Protection - Honeywell Home T6 Pro Guide De L'utilisateur

Adjusting keypad lockout
1 Press Menu on the thermostat.
to go to LOCK. Press Select.
2 Press or
to go to OFF, PART, or ON, and then press Select.
3 Press or
OFF: Unlocked, and full access allowed.
PART: Partial lockout, allowing only the temperature to be changed.
ON: No access allowed.
4 To unlock the keypad, press the CENTER button and then enter the password
"1234". To enter the password, press
number. Then press Select. Repeat this process to enter the second through
fourth digits of the number. Once all four numbers have been entered, press
Select again.
5 This will unlock the keypad.
6 If the code is incorrect, the screen will flash the lines "--".
7 Press Back to go back a step to enter the correct number and press Select.

Adaptive Intelligent Recovery

Over time, the Honeywell T6 Pro Thermostat "learns" how long it takes your
system to reach the temperature you want. It turns on the heating or cooling
system earlier to make sure you're comfortable at the time you expect.

Built-in compressor protection

Damage can occur if the compressor is
restarted too soon after shutdown. This
feature forces the compressor to wait for a few
minutes before restarting.
During the wait time, the display will flash
the message Cool On (or Heat On if you have
a heat pump). When the safe wait time has
elapsed, the message stops flashing and the
compressor turns on.
or to change the first digit of the
Message flashes until safe
restart time has elapsed.
5