How To Connect Directly To Your Router; How To Improve Your Wireless Connection Speed; How To Change Your Network's Name And Password - Linksys WRT1900AC Mode D'emploi

HOW TO CONNECT DIRECTLY TO YOUR ROUTER

You can configure your router by directly accessing it on your home network instead
of through the Internet-based Linksys Smart Wi-Fi.
To connect to your router while you are on your home network:
• Open your computer's web browser.
• Go to www.linksyssmartwifi.com and log into your router using the router
password you created when you installed your router. (When there is no Internet
connection, this address re-routes directly to your router.)

HOW TO IMPROVE YOUR WIRELESS CONNECTION SPEED

Make sure that your router is in a good location:
• For the widest coverage area, install your router near the center of your home, and
near the ceiling, if possible.
• Avoid placing the router on or near metal objects (file cabinets and metal furniture),
reflective surfaces (glass or mirrors), or masonry walls.
• Any obstruction can weaken the wireless signal (even non-metallic objects), so the
fewer obstructions between the router and the wireless device, the better.
• Place the router in a location away from other electronics, motors, and fluorescent
lighting.
• Many environmental variables can affect the router's performance, so if your
wireless signal is weak, place the router in several locations and test the signal
strength to determine the ideal position.
• If possible, upgrade wireless network interfaces such as wireless network cards
in computers from older wireless standards to 802.11n. If a wirelessly networked
device uses an older standard, the performance of the entire wireless network may
be slower.
• If your router is a dual-band router, split your network traffic so the high-bandwidth
traffic uses the 5 GHz band. For more information, see "How to get the most out of
your dual-band router" on page 22.
WRT 1900AC | Setting Up: Basics

HOW TO CHANGE YOUR NETWORK'S NAME AND PASSWORD

You can change the name (SSID) and password of your network, but if you do so,
all wireless devices connected to your router will lose their Internet connection
until you reconnect them using the new network name and password.
To change your router's name and password:
• Log into Linksys Smart Wi-Fi. (See "How to connect to Linksys Smart Wi-Fi" on
page 7.)
• Under Router Settings, click Wireless.
• Click the Wireless tab, then click Edit.
To change the network name, type a new name in the Network name (SSID) box.
To change the network password, type a new password in the Password box.
•. Click OK to apply your changes.
8