LEMAN LOSAE250 Manuel D'utilisation page 23

5. Trouble shooting
Faults which occur while you are using your machine often have simple causes which you should know and should
be able to rectify yourself.
In cases of doubt, please contact our After Sales Service.
Problem
The machine does not start.
The motor has no power or
the vacuuming/blowing is not
efficient.
Machine vibrates heavily.
- If you are unable to eliminate the error yourself, please contact our After Sales Service.
- Repair, modification and inspection must be must be carried out by a LEMAN Authorized Service Center.
- In the operation and maintenance, the safety regulations and standards prescribed in each country must be
observed.
MODIFICATIONS:
LEMAN Power Tools are constantly being improved and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed without prior notice.
Do not dispose of electric tools together with household waste material!
In observance of European Directive on waste electrical and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
GB
Possible cause
No power supply.
Mains connection defective.
Extension cable too long or cross
section too small.
Collection bag is full.
Material is too wet.
Turbine is damaged.
Vacuum/blow pipe is blocked.
Machine is damages.
DISPOSAL
23
Solution
- Check the cable, and the plug.
- Check the fuse.
- Contact our After Sales
Service.
- Extension cable min. 1.5 mm²,
max. 25 m long.
- For longer cable, cross section
min. 2.5 mm².
- Empty the collection bag.
- Vacuum/blow dry material.
- Contact our After Sales
Service.
- Remove and clean the pipes.
- Contact our After Sales
Service.