Hitachi Koki Tanaka TCG 23ECP (SL) Instructions De Sécurité Et Mode D'emploi page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
○ Check that the cutting attachment is properly
centred, sharp, and without cracks. An off -centre
cutting attachment induces heavy vibrations that
may damage the unit.
○ Check that the cutting attachment nut is
suffi ciently tightened.
○ Check that nuts and screws are suffi ciently
tightened.
○ Check that the unit is undamaged and free of
defects.
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the
problem, consult your dealer or the Tanaka dealer.
Condition
Fuel
system
Engine does
not start
Electrical
system
Other
16
Cause
Fuel tank is empty or fuel level is
low
Fuel tank contains old fuel (off ensive
odor)
Too much fuel is absorbed and
spark plug is wet
Fuel fi lter is clogged with dirt
Fuel pipe is bent or disconnected
Carburetor malfunction
Stop switch lead has short-
circuited
Spark plug is dirty
Electrode gap is too big
Poor connection between high
tension cable and spark plug
Electrical system malfunction
Muffl er exhaust port is clogged
with carbon
Weekly maintenance
○ Check the starter, especially the cord.
○ Clean the exterior of the spark plug.
○ Remove the spark plug and check the electrode
gap. Adjust it to 0.024˝ (0.6 mm), or change the
spark plug.
○ Check that the angle gear is fi lled with grease up
to 3/4.
○ Clean the air fi lter.
Monthly maintenance
○ Rinse the fuel tank with gasoline.
○ Clean the exterior of the carburetor and the
space around it.
○ Clean the fan and the space around it.
Remedy
Fill the fuel tank with the correct fuel mix
(25:1-50:1)
Replace with new fuel
1. Disconnect the spark plug and allow
to dry
2. Pull the starter handle 5 or 6 times to
remove the surplus fuel
3. Attach the spark plug
4. Set the choke lever to RUN position
and pull the starter handle
Clean the fuel fi lter
Ensure that the fuel fl ows smoothly
Contact Tanaka dealer
Contact Tanaka dealer
Replace or clean the spark plug
Adjust the gap to 0.6 mm
Reconnect
Contact Tanaka dealer
Contact Tanaka dealer for repair

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tanaka tcg 23ecp (slb)

Table des Matières