Hitachi Koki Tanaka TCG 23ECP (SL) Instructions De Sécurité Et Mode D'emploi page 15

4˝ (10 cm)
(4) Push each line into the stopper holes (19),
leaving the loose ends approx. 4˝ (10 cm) in
length. (Fig. 26)
(5) Insert both loose ends of the line through the
cord guide (20) when placing the reel in the case.
(Fig. 27)
NOTE
When placing a reel in the case, try to line up the
stopper holes (19) with the cord guide (20) for
easier line release later.
Fig. 25
19
Fig. 26
19
20
Fig. 27
(6) Place the cover over the case so that the cap
locking tabs (21) on the cover meet the long
holes (22) on the case. Then push the case
securely until it clicks into place. (Fig. 28)
18
(7) The initial cutting line length should be approx.
4-11/32˝–5-1/2˝ (11–14 cm) and should be equal
on both sides. (Fig. 29)
4-11/32˝–5-1/2˝
(11-14 cm)
For long-term storage
Drain all fuel from the fuel tank. Start and let engine
run until it stops. Repair any damage which has
resulted from use. Clean the unit with a clean rag, or
the use of high pressure air hose. Put a few drops
of two-cycle engine oil into the cylinder through the
spark plug hole, and spin the engine over several
times to distribute oil.
Cover the unit and store it in a dry area.
Maintenance schedule
Below you will fi nd some general maintenance
instructions. For further information please contact
Tanaka dealer.
Daily maintenance
○ Clean the exterior of the unit.
○ Check the cutting attachment guard for damage
or cracks. Change the guard in case of impacts
or cracks.
English
21
22
Fig. 28
4-11/32˝–5-1/2˝
Fig. 29
15