Inserting The Memory Card; Basic Operation - Berger & Schroter 31881 Instructions D'utilisation

Inserting The Memory Card

Please prepare a Micro SD card and insert it into the camera for saving
files. Before recording, please format the memory card first.
• Support Micro SD card,up to 32GB. Suggest to use class 6 or above
high speed card.
• To avoid malfunction, the memory card should be far away from water,
strong vibration,dust, hot source and direct sunlight.
• Do not insert the memory card forcibly. Please refer to the marking on
the camera.
• For the first time use, please wait for the memory card temperature
reach the ambient temperature.The camera will be short-circuit influen-
ced by environment temperature and humidity. Please notice protection
for the camera when using it outdoor.
• If the capacity of memory card is full, the camera will stop recording
automatically.
• Press the edge of the card gently to pop-up the TF card.

Basic Operation

Turn On And Off The Camera
Switch the Mode Button to"Test/On"to turn on the camera.
Switch the Mode Button to "Off" to turn off the camera.
System Setup
Switch Mode Button to "Test", then you can set the system parame-
ters.
1. Press Menu button to open the setup menu.
2. Press Up/Down button to scan all menu. Then press OK button to
enter the options interface.
4. Press Up/Down button to scan all options. And press OK button to
confirm options.
5. Press Menu button again to turn back to last menu or exit the setup
menu.
Setup menu and function as below:
15