Publicité
Les langues disponibles
Les langues disponibles
Step 11.
Slide the pre-assembled cross tie bar (O) into the tie bar (N) as figure (1) shown.
◆
Place the support bar for middle slide chute (U) into rounded-pedestal on the reverse of
◆
middle slide chute (L).
◆ Thread the cross tie bar (O) and tie bar (N) and support bar for middle slide chute (U)
with hardware (bolt Cx1 + washer Fx1 + spring washer Gx1 + domenut Hx1).
Step 12.
Connect the support bar (Q) into the ladder stablilizer bar (P) with hardware
◆
(bolt Cx1 + washer Fx1 + spring washer Gx1 + domenut Hx1).
Rounded - Pedestal
P
Q
P
C (M6x35) 1x
F (M6)
1x
G(M6)
1x
H(M6)
1x
2x
C (M6x35)
F (M6)
2x
G(M6)
2x
H(M6)
2x
Publicité
