Appendix A (Intermittent Pilot & Valve Kit) - Inca Metal Cutting INFINITY Serie Manuel D'installation Et Guide De L'utilisateur

Table des Matières

Publicité

8.0 LABEL INFORMATION (continued)
This appliance is equipped with a three prong (grounding) plug for your protection against shock
hazard and should be plugged directly into a properly grounded three prong receptacle. Do not cut or
remove the grounding prong from this plug.
Cet appareil est équipé d'un à trois broches (terre) pour votre protection contre les risques de choc
électrique et doit être branché directement dans une prise à trois broches récipient. Ne pas couper ou
This appliance must be properly connected to a
venting system in accordance with the
manufacturer's installation instructions.
This is a direct vent appliance.
This appliance must be installed in accordance
with local codes, if any; if none, follow the
National Fuel Gas Code, ANSI Z223.1/NFPA
54,or the Natural Gas and Propane Installation
Code, CSA B149.1.
WARNING: Improper installation, adjustment,
alteration, service, or maintenance can cause
injury or property damage. Refer to the
manufacturer's manual provided with this
appliance. For assistance or additional
information consult a qualified installer,
service agency, or the gas supplier.
WARNING
Electrical Grounding Instructions
AVERTISSEMENT
Instructions à la terre électrique
retirer la broche de terre de cette fiche.
Page 50 of 55

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Infinity-50Infinity designer clean face serie

Table des Matières