Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 4 screws BHc 5×35 black big head
- 2 plastic spacers 6x10x20
- 2 rubber spacers Ø6 L : 5 mm
- 4 plastic washers Ø5
Fitting instructions
- Remove the original windshield.
- Place the Ermax windshield on the scooter. Screw it at the bottom with 2 screws BHc 5×35, by inserting the
rubber spacers between the windshield and the scooter. Fit the windshield on the top points with 2 screws BHc
5×35, by inserting the plastic spacers between the windshield and the scooter.
- Mirrors position may be adjusted to avoid contact with the windshields when using.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
ADAPTABLE ON 125 NMAX 2015 → ∞
Plastic spacers location
« CAUTION »
Update : 24/07/17
FITTING INSTRUCTIONS
ERMAX FLIP UP WINDSHIELD
Estimated mounting time
EN
: 10 mn
Publicité
