Publicité
Les langues disponibles
Les langues disponibles
:
CHARGE TIME
Capacity (Ah)
Time in Mins
:
CHARGING PROCEDURE
1 • Connect the power supply output plug to the input socket
on the charger, and then plug the other side cord into an
appropriate AC wall socket.
2 • Insert the battery pack into the charger, making sure the
pack is fully seated in the battery cavity. The red light will
come on indicating that the charging process has started.
3 • The charger will show a blinking red light when the
battery pack is fully charged. If the battery is left in the
charger after the battery is fully charged it will
automatically switch to trickle charge mode.
4 • After charging is complete unplug the charger from the
power source.
:
LIGHT INDICATORS
• Pack charging: Steady red light
• Fully charged: Red light blinks at once per second
• Faulty battery: Red light blinks at 3 times per second
• Short circuit: Red light blinks at 3 times per second
• Battery temperature delay: steady red and green light
INSTRUCTION MANUAL
Charger for Hitachi batteries 7.2V to 18V
(NiCd, NiMH and Li-ion)
CHARGER SPECIFICATIONS
• The separate universal AC adaptor (power supply) can be used with
world wide AC voltage of 100V~240V, 50~60Hz.
It has an output of 36V DC 2Amp and is plugged into the battery
charger unit.
Nickel Cadmium
1,3
1,5
2,0
52
60
80
Nickel Metal Hydride
2,1
2,5
3,0
3,3
84
100
120
132
:
CHARGING ADVICE
• DO NOT charge the battery pack in an air temperature below
+0ºC (32ºF), or above +40ºC (104ºF). This is important and
will prevent serious damage to the battery pack.
• It is normal for the charger and battery pack to become
warm to the touch while charging.
• DO NOT CONTINUE to use a battery with low voltage or
capacity. Immediately charge the battery.
:
CAUTION
• Please read all instructions before using the charger.
• This charger is designed for indoor use only.
• Do not probe with conductive metal objects during charging.
• Do not insert a cracked or damaged battery into the charger
• Do not allow any liquid to get inside charger. Keep it away
from water and moisture.
• Make sure the power supply and adaptor cord is located so
that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
• To reduce the risk of damage to the electric plug and cord
when disconnecting the charger from the wall socket, pull by
the plug rather than the cord.
• Use only the power supply supplied, to avoid any possible
damage to the charger
CEH9107
Li-Ion
3,0
120
Publicité
