Publicité
Les langues disponibles
Les langues disponibles
BFL(T)
Servomotor Belimo
Mounting of the mechanism
On damper type CR2, CU2, CU2-15, CU4, CA2:
1. Mount the axis on the
base plate. Use universal
grease around the axis.
2. Retrieve the operating
arm, bolt and washer of
the old mechanism and
mount them on the new
base plate.
On damper type CR60, CR120, CU-LT(1s):
If the product is manipulated in any other way than described in this manual, Rf-Technologies
will decline any responsibility and the guarantee will immediately expire!
3. Mount the base plate
with the enclosed screws
on the tunnel of the
damper.
1. Make sur the damper blade is closed.
2. Place the position indicator arrow on the motor on position 0°.
3. Fix the motor, L side visible, with screws and spring washers.
4. Connect the motor according to the wiring diagram.
5. Place the thermo-electric fuse on the holder and fix with 2 screws (type BFLT). If the
old motor was not equipped with a thermo-electric fuse, the membrane must be
perforated first.
6. Test that the motor functions properly.
7. Apply the label 'KIT' to the motor and fill in the details.
4. Caution: make sure the
operating arm is fitted in
the transmission arm.
K128 - A
08/2015
5. Make sur the damper
blade is closed.
6. Place the position
indicator arrow on the
motor on position 0°.
7. Fix the motor, L side
visible, with screws and
spring washers.
8. Connect the motor
according to the wiring
diagram.
9. Place the thermo-
electric fuse on the plate
and fix with 2 screws
(type BFLT). If the old
motor was not equipped
with a thermo-electric
fuse, the membrane
must be perforated first.
10. Test that the motor
functions properly.
11. Apply the label 'KIT' to
the motor and fill in the
details.
13
Publicité
