Service, Troubleshooting And Repair; Service Information - Eskimo Stingray S33 Manuel De L'opérateur

33cc
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SERvICE, TROublESHOOTING
AND REPAIR

SERvICE INFORmATION

At Ardisam, we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life
for your auger. Most repairs will be minor, and easily fixed by
following the suggestions in the troubleshooting guide in this
section.
The guide will help you pinpoint the causes of common prob-
lems and identify remedies.
For more complicated repairs, you may want to rely on your
retailer or an authorized repair center (contact your retailer for
a list of authorized mechanics in your area). A parts catalog is
included in this section and can also be found on our website,
www.geteskimo.com.
We will always be glad to answer any questions you have, or
help you find suitable assistance. To order parts or inquire
about warranty, call or write us at the address found below,
under the section ordering repair parts.
ICE POINT REPlACEmENT (SEE FIGuRE 1)
1. Remove blade protector and both blades.
2. Remove nut and retaining bolt from point.
3. Using a locking pliers, grasp point and pull out. If holder
doesn't come out with the point, remove with pliers.
4. With locking pliers, push in new point and holder aligning
bolt hole in point with holes in auger shaft. DO NOT dam-
age end of point.
NOTE: When installing holder in auger shaft, edges of
holder may shave off.
5. Insert retaining bolt and tighten with nut.
6. Re-attach both blades and put blade protector back on.
10
AvOID INjuRY! AuGER blADES AND POINT ARE
ExTREmElY SHARP. uSE CAuTION WHEN REmOvING
& REPlACING.
PRACTICE SAFETY AT All TImES. ENGINE muST bE
TuRNED OFF AND AllOWED TO COOl, AND SPARk
PluG WIRE muST bE DISCONNECTED bEFORE
ATTEmPTING ANY mAINTENANCE OR REPAIR.
Figure 1
ORDERING REPAIR PARTS
Parts may be obtained from the store where your auger was
purchased or direct from the factory. To order from the factory,
call, e-mail, or order online at www.geteskimo.com:
Please include the following information with your order:
1. Part numbers
2. Part description
3. Quantity
4. Model number and serial number
Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST
33cc Stingray™ Power Ice Auger
CAuTION
auger shaft
nut
point
Eskimo Ice Fishing Gear,
A Division of Ardisam, Inc.
1-800-345-6007
E-mail: info@ardisam.com
Operator's Manual
holder
bolt
bolt hole

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Stingray s33q8

Table des Matières