Programming Table - Taralog Version Tg2Tct251En - JEAN LUTZ TARALOG Mode D'emploi

Programming table - TARALOG version TG2TCT251EN

Names and numbers
of Menus
1 Sensors
2 MEMOBLOC
3 Time and Date
4 Configuration...
Names and numbers of
submenus
Adjustments of different sensors : zero, full scales, etc.
11 Depth
12 Flow and volume
13 Rotation speed
14 Concrete pressure offset
15 Torque pressure offset
16 Torque unit and factor
17 X angle offset
18 Y angle offset
19 Traction pressure offset
1A Thrust pressure offset
Adjust the parameters of the numerical registration on the MEMOBLOC
21 Digital Selection
22 Recording step
23 "MEMOLEC" mode
To set TARALOG's internal time and date
31 Adjustments
Information which will be displayed on the screen and formatting.
41 Depth, Overbr. Profile
range
42 Graphic scale
43 Horizontal, overbr. bar
44 Auto offset pres. conc.
Depth encoder coefficient (pulse/m) and
positive / negative displacement (1/2)
Volume per pump stroke.
Stroke detection adjust (cl/pulse).
Number of bolts detected by the rotation
sensor (pulse/revolution)
Volume per pump stroke.
Stroke detection adjustment (cl/pulse)
Unit and conversion factors for torque
calculation (bar or t.m)
If t.m : speed coefficient in Kg.m/bar
Inclinometer zero correction X (mA)
(Standard value : 12 mA)
Inclinometer zero correction Y (mA)
(Standard value : 12 mA)
Traction sensor connection (mA) (option)
(Standard value : 4 mA)
Thrust pressure sensor correction (mA)
(option)
(Standard value : 4 mA)
Recording of data in MEMOBLOC (yes/no)
Recording step adjustment in cm
Standard value : 8 cm
MEMOBLOC access by PC
Modification if necessary.
Maximum depth on the screen (m)
Graphic scales in drilling mode.
Graphic scales in concreting mode.
Overconsumption
around the instruction which allow to place the
cursor and full scale of the bargraph.
Automatic offset of concrete pressure at the
64
Comments
instruction : tolerances