About Recording; Before Recording; Turn The Microphone Toward The Original Sound Source - Olympus LINEAR PCM RECORDER LS-10S Mode D'emploi

Before Recording

Getting Ready
Affi x the windscreen:
Start recording after attach the
windscreen (optional) to the
microphone. The noise may
occur even if a windscreen is
2
attached when forcing wind
blows against a microphone.

Turn the Microphone Toward the Original Sound Source

Turn the built-in stereo microphone in the direction that you would like to record. Placing the built-in stereo
microphone over the display is the proper position for performing stereo recording. If it is below the display
when recording then proper stereo recording cannot be performed because the position of the original
sound will be recorded in reverse phase.
Original
sound
source
When recording with the
built-in microphone:
Turn the microphone in the direction
of the source to be recorded.
22

About Recording

Select the media for recording:
The built-in flash memory as well as an SD
Card can be used (☞ P.17, P.41, P.46).
Select the recording format:
Recording can be performed through the
linear PCM format, as well as the WAV, MP3
and WMA formats (☞ P.41, P.43).
About the built-in stereo microphone:
The direction of capturing sound by the microphone
can be changed with the MIC SENSE HIGH/LOW switch
(☞ P.27).
On mounting:
Accurate adjustments of the microphone's angle and
the like can be made when the device is affixed to a
commercially available tripod used for cameras.
MIC SENSE HIGH
MIC SENSE
LOW
L R
Key map