Programming Instructions - Alcad PAK-54010 Mode D'emploi

HOW TO CONNECT THE PANEL WITH DIRECTORY
Lighting of the panel with directory
DESCRIPTION
The connection bracket/telephone must be programmed from the main entrance panel of the system (
instructions ).
The programming code is stored in the connection bracket/telephone. If the connection bracket/telephone is replaced, remember to re-program it.
In installations where several devices (i.e. telephones or monitors) are associated to the same call line (in parallel), each device should be
programmed separately but all should have the same code.
2 - W I R E
RVE-018
cod.9770054
Ctrl2
C2 NO2 NC2
A
trl2
B

PROGRAMMING INSTRUCTIONS

Programing switch
Programming switch
D O O R E N T R Y
OUT
KPD-521
cod. 9650015
CC0
–
Ctrl2
B
Permanent lighting
Lighting by pressing any key on the entrance panel
S Y S T E M S
SC2
USB
Lock release
Monitor
Lock release
Entrance panel with keypad configuration
Monitor