Safety Precautions - Drive Medical Breast Cancer Awareness Mode D'emploi

Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
Loop Locks
Safest System
Available
Backrest
Height
Adjustable
Folding
Hinge for
Portability
assembly instructions
1. Remove all contents from carton.
2. Open frame and place up-side-down on the floor. Attach legs
without brakes to the front of the walker by depressing push
pin and sliding leg into the receptacle. Secure in place using
the tightening knob, threading the knob in from the outside.
Repeat for second leg, making sure both legs are set to the
same height.
3. Attach back legs (with brakes) using the same process,
making sure the wheels are on the outside of the rollator and
are at the same height as the front wheels. Affix brake cable
to the black portion of the leg using the "S" shaped clamp
provided.
4. Insert handle tube into frame and set to desired height.
Secure in placed using tightening knob, threading the knob
in from the outside. Repeat for second handle, making sure
both are set to the same height.
5. Attach padded backrest by depressing the black thumb
buttons and sliding into the black bracket. Note that back
rest can be folded up when not in use.
Orthodic
Hand Grips
Wide
Comfortable
Seat
Hanging Bag for
Functionality &
Storage

safety precautions

1. Please make sure the Rollator is fully opened, seat is down
and the folding bar under seat is locked in the down position.
2. Be sure that both knobs are fully tightened and are at equal
heights. Test Rollator for stability before applying full weight
to hand grips.
3. Test the loop locks before operating the Rollator. When
wheels are locked (see illustrations for locking and releasing
locks below), lock bar on rear wheels should prevent wheels
from turning. If the wheels turn while brakes are locked,
please take unit back to dealer for adjustment. When locks
are released, the wheels should turn freely.
4. Always lock loop locks before sitting and do not use seat
when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
6. Do not have anyone push you while you are seated on the
Rollator. This is a walking aid only and is not to be used as a
transportation device.
loop lock operation
Always engage and disengage wheel locks on both sides
simultaneously.
1. To Slow Down or Come to a Temporary Stop — Pull up slowly
on the loop locks with four fingers until unit slows down or
comes to a temporary stop.
2. To Temporarily Lock Wheels in Position — Press down on
both loop locks with palms until you hear a "click" that will
tell you wheels are locked.
3. To Release Wheel Locks — Push up on both loop locks with
palms of hand to original position.